H - 2000 Manual Spray Gun Set Car

Features:
- Stainless steel needle and nozzle accommodate a variety of coatings
- Built-in 3 control knobs to adjust fluid, pattern and air easily
- Smooth surface treatment, feel comfortable
- Transparent spray cup, you can clearly see the liquid capacity
- Easy trigger pivot reduces your operating fatigue
- No waste of paint
- Light weight, good atomization effect
- Wide range of applications

Specifications:
- Materials: aluminum
- Spray cup thread diameter: 16mm
- Cup capacity: 125ml
- Air pressure: 43 PSI
- Nozzle diameter: 0.8 / 1.0mm
- Working pressure: 2.5 - 3.5bar

Preparing for work:
- Check and replace any damaged or worn parts on the tool
- Make sure the trigger and nozzle can operate well
- Connect the gun to air supply, fluid cap, container and air hose should be connected tightly with spray gun
- Required air pressured should be adjusted by viscosity and feature of paint. Proper air pressure of 3 - 5bar should be recommended
- Pour paint into the container cup

Maintenance:
- Pour remaining paint into another container and then clean paint passage and air cap. Spray a small amount of thinner to clean the passage. Incomplete cleaning will cause adverse pattern sharp and particles. Clean fully and promptly two-component paint after using
- Clean other sections with attached brush soaked with thinner and soft clothes
- Clean paint passages fully before disassembly
- Remove fluid nozzle after removing fluid needle set or while keeping the fluid needle pulled, in order to protect seat section

Caution:
- Never spry foods or chemicals through the spray gun
- Connect a fluid hose or a container to fluid nipple tightly
- Never use the wire or other hard thing to dig nozzle, fluid needle, this will cause the damage of them
- Never immerse the whole gun into solvent, because it will damage the air cap, fluid nozzle, fluid needle